Today, I’m at the TusCon Science Fiction Convention in Tucson, Arizona. You can get all the details about the event at http://tusconscificon.com. One of the topics I’ll be speaking about is the work we’ve been doing for the last year, installing the DESI Spectrograph on the Mayall 4-meter telescope. At this point, installation is nearing completion and we’re beginning the process of commissioning the instrument. In short, we’re actually making it work with the telescope so we can get the data we hope to obtain.
DESI isn’t the only instrument that we’ve recently installed. We’ve also installed the NEID spectrograph on the WIYN telescope. While DESI has the goal of making a 3D map of about one-third of the sky, NEID has the goal of looking for planets around other stars. I’ve shared quite a bit about the DESI installation because that instrument is of a scale that it required a major refit of the telescope. The NEID spectrograph has involved a similar amount of time in development, but much of that development has happened off site at places such as Penn State University and the University of Wisconsin. NEID, which rhymes with fluid, takes its name from the Tohono O’Odham word meaning “to see.”
Two weeks ago, the port adapter, built by the University of Wisconsin, and the spectrograph, built at Penn State University, both arrived at WIYN and have been installed at the telescope. You can see the port adapter on the side of the telescope in the photo above. It’s job is to capture light coming through the telescope from a distant star and feed it into fiber optics that run downstairs to a high precision spectrograph.
The spectrograph itself lives in a clean room on the WIYN Observatory’s ground floor. To get the kind of precision needed to see planets around other stars, the temperature within the spectrograph must be carefully maintained and the spectrograph elements must be kept in the same relative position. Footsteps nearby could disturb this device. Because of that, the spectrograph itself is built inside a coffin-like housing. Once the Penn State team gets everything set up, they’ll seal up the coffin and, unless there’s a serious problem, no one will look inside again. I got to peak inside the spectrograph a few days ago and it may be my only view.
Now that the instrument is installed at the telescope, we have to make sure everything works as it should and programmers are working to make sure we have software to assure we can efficiently get the data we need. We’re starting with the port adapter itself. I point the telescope at stars and a team of scientists and engineers check the function of the various parts within the adapter to make sure they understand the alignments on the sky, which are necessary for tracking the stars. They check the tip-tilt electronics, which make sure we get as much of the star’s light as possible down the fiber, and make sure all the calibration functions work. After this, work will begin commissioning the spectrograph itself. This is a process which takes a few months to complete to assure we’re getting the performance out of this instrument that we want.
Commissioning nights are very different from normal observing nights at a telescope. On a normal observing night, it’s often me and an observer. Often the observer isn’t even at the telescope, but working from their home institution, controlling a camera on the telescope over the internet and talking to me through computer chat. On a commissioning night, I can have anywhere from five to fifteen people in the control room with me, all working on different elements of the instrument. This marks a busy and exciting time as we get these new instruments ready for service at Kitt Peak National Observatory.